With an extra pair of hands it takes no more than 10 seconds to get it positioned properly. Trying to line up the clips on one side of the van while trying to keep the other end from twisting on you and torqueing the clips would be very difficult to do alone. Maneuvering it without risking damaging it is a two-person job. It is not heavy but it is very awkward because if you grab one end the other will flop around on you it's not a very rigid piece of plastic. It most likely required a second removal of the bumper to find and repair the broken wire.Ĭlick to expand.I just did a hitch install on my 2015 (I know that's the previous generation but this would apply equally to the gen 5 Ody) and had to remove and replace the rear bumper cover. I had to bring the vehicle back and leave it. I left the dealership and my parking sensor warning light came on. And as I already said, on the installation of the two rods, a wire was accidentally broken. Now the bumper is out very slightly and will be a dirt catcher and a slight drag on airflow. I find that to be incredible but they are not going to do anything about it. Once the bumper has been removed something changes and there is nothing they can do to make it as new. And they said that they never go back in flush, like-new from the factory. However, the plastic bumper is now protruding out from both sides of the minivan slightly and the panels are not flush. So installing the new parts was a necessity. They said that if the antenna was not replaced there would be a hump in the bumper. VERSATILE: This DRAW-TITE Class 3 hitch is designed to fit the following make and model year vehicle(s): 1999-2017 Honda Odyssey.I met with the service manager and he called in the mechanic who installed the hitch.The 2 inch square receiver can connect to a ball mount, bike rack, cargo carrier, and more! Also suitable for use with Weight Distribution systems of up to 5,000 lbs. TESTED: DRAW-TITE hitches are inspected for quality and workmanship and are tested to meet and exceed V-5 and SAE J684 standards.Each is also protected by a two-part black powder coat finish to resist rust and corrosion. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |